Page 3-14
User Guide
PROGRAMMING THE REMOTE TO CONTROL OTHER DEVICES
1. Turn on the electronic device you want the remote to control. You must turn on the
device using its buttons or the remote control that came with it.
2. Find the brand name of the device in the device code tables starting on page 3-16.
If the brand is not listed, go to the “Performing the Remote Control Device Code
Scan” below.
3. Press and hold the Mode button for the device you want the remote to control for
about 3 seconds. When all other mode lights come on, release the button. It will flash
to indicate it is in the address programming format.
4. Use the number pad buttons to enter the code for the device. If you are programming
the AUX mode, you must enter a 4-digit code. The first digit is the code for the
device, as follows:
• 0 - indicates a second TV
• 1 - indicates a second VCR
• 2 - indicates an audio amplifier or cable box
For example, if you are programming the remote to control a second TV, the mode
should be AUX. Enter 0 and then the three digit code for that device.
5. Press and release the (#) button. If the code is valid, the mode light will blink three
times.
6. Test if the code works for the device by pressing the Power button. If the code
works, the device should turn off.
7. Turn the device back on and try some other functions to make sure they work.
Occasionally, the Power button may work when other buttons do not. If the code
works for other functions, stop here.
8. If the code you entered does not work, repeat the steps 3 - 5 using another code from
the tables.
9. If you have tried all of the codes listed for the device without success, or if you can
not find the device brand name in the tables, use the Device Code Scan procedure,
explained on the following page.
PERFORMING THE REMOTE CONTROL DEVICE CODE SCAN
If a device brand is not listed in the code tables or if the listed codes do not work, you
can scan through all the codes, testing each one. The remote may not control some
brands or models of devices.
If you start this procedure and at any time do not press a button within 20 seconds, the
remote will end the procedure automatically. This does not indicate that anything is
wrong with the remote control. Simply start the procedure over again.
1. Press and hold the Mode button for the device you want the remote to control for
about 3 seconds. When all other mode lights come on, release the button. It will flash
to indicate it is in the address programming format.
For AUX mode only, use the number pad buttons to enter the number as indicated
below. The press the star (*) button. This defines the device for which you are
scanning as follows:
(52 Seiten)
(21 Seiten)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern